80-mm total length. The trough was filled with water (26°C ± 0.1°C) serving as the subphase. Solutions of SA and BSA were carefully transferred and spread randomly onto the subphase (water) using a Hamilton microsyringe (precision to 0.5 μl). The solutions were left for about 10 min to allow the solvent to evaporate before the π-A isotherms were measured. The films were compressed at a rate of 10 mm min-1. Y-type deposition of pure SA and SA/BSA on substrate Silicon (100) wafers were cut into approximately 5 cm × 1 cm pieces

and placed in a furnace (Carbolite, Watertown, WI, USA) for 8 h at 900°C to allow oxidation. The oxidized silicon wafer was clamped vertical to the subphase and immersed into the dipping well before spreading the monolayer material. After complete evaporation of the solvent, the floating layer was compressed at a Idasanutlin mw rate of 10 mm min-1 to reach a target surface BAY 63-2521 purchase pressure of 20 mN m-1 and kept for 15 min to attain stability for deposition. The Y-type deposition of LB film was performed at the targeted pressure with a dipping speed of 10 mm min-1. All the transferred films were kept for a week in a dry, clean and closed container before atomic force microscopy (AFM) imaging. AFM imaging High-resolution imaging of bilayers

was obtained by AFM after transferring them from the air/water interface to a solid oxidized silicon substrate. Mixed bilayers from the Langmuir trough were transferred onto oxidized silicon substrates at the desired Wilhelmy pressure. Bilayers transferred to substrates were imaged using the NanoScopeIIIa scanning probe microscope

controller (Veeco Instruments Inc., Plainview, NY, USA) in tapping mode under ambient conditions. Aluminum probes (Budget Sensors BS Multi 75Al, Innovative Solutions Bulgaria Ltd., Sofia, Bulgaria) were used. Resonance frequency of the probe was 75 kHz, and the force constant was 3 N m-1. Images in height mode were collected simultaneously with 256 × 256 points at a scanning rate of 1.0 Hz per line. A series of AFM images were taken from different perspectives. Dichloromethane dehalogenase Results and discussion π-A measurements and analyses π-A isotherm Figure  1 shows a comparison between the surface pressure (π)-area (A) isotherms of the SA/BSA monolayer and the SA monolayer. The limiting area of the pure SA monolayer was estimated to be 21 Å by extrapolating the straight portion of the π-A isotherm to zero surface pressure. The starting point of the straight portion at 20 to 25 mN m-1 represented a phase transition from liquid-condensed to the solid state (to be discussed later in the compressibility analysis). The SA monolayer collapsed at the surface pressure of 45 mN m-1. Figure 1 π-A isotherms for SA, PX-478 concentration mixtures of SA/BSA and BSA at the air/water interface at 26°C. When BSA was incorporated into the SA monolayer, the shape of the π-A isotherm gradually changed with increasing concentrations of BSA.