5, 1, 2, 3, 4, 5, 6, 8, 10, 12, 24 and 30 h post dose. After 4 h of dosing, the volunteers were given controlled diet. Sampling was continued for 30 h. The blood samples were centrifuged immediately at

5000 rpm and the separated plasma samples were stored at −70 °C until analysis. The study design used is a randomized, crossover, non-blinded, design. A sensitive HPLC method5 was used to analyze the aceclofenac in human plasma. The HPLC system (Make: M/s Shimadzu Corporation, Japan.) www.selleckchem.com/products/dabrafenib-gsk2118436.html consisted of UV–Visible detector (Shimadzu, Model: SPD – 10AVP). To 500 μl of plasma, 400 μl of acetonitrile solution containing ibuprofen (10 μg/ml) as an internal standard was added and mixed for a minute. Diluent (100 μl) was added and centrifuged at 5000 rpm selleck inhibitor for 20 min. The supernatant layer was collected and analyzed using HPLC. The chromatographic conditions used: mobile phase: a mixture of phosphate buffer 6.8 (pH adjusted to 6.8 using phosphoric acid) and acetonitrile (30:70); Column: C-18 column (Phenomenex, DESC: Gemini 5 μ C18 110 A, Size: 250 × 4.6 mm, S/No: 288063 – 23); Flow rate: 1 ml/min; injection volume: 20 μl; temperature: 25 °C; run time: 12 min; detection wavelength: 275 nm; internal standard: ibuprofen. The formulae of different aceclofenac matrix tablets prepared, employing PEO N60K and PEO 303 polymer at 20%

and 40% w/w, are shown in Table 1. The drug release profiles from these matrix tablets are given in Fig. 1. The drug was released rapidly from F1 and F2, but from the formulations F3 and F4, the release was much slower and was sustained up to 20th and 24th hours. Photographs showing the swelling and erosion of two different tablets, F2 (PEO N60K) and F4 (PEO 303) at 0, 1, 2, 4 and 12 h are shown in Fig. 2. Aceclofenac first release profiles

from matrix tablets containing different percentages of PEO 303, 24% (F5), 28% (F6), 32% (F7) and 36% (F8), are shown in Fig. 3. The aceclofenac release decreased with increasing PEO 303 amount. In the case of formulation F5 the drug release is completed within 20 h. The pharmacokinetic parameters like area under the curve AUC0–30, time to peak plasma concentration (Tmax) and peak plasma concentration (Cmax) were calculated from the plasma concentration time curves and are shown in Fig. 6 and Table 3. Aceclofenac could be traced in blood for 30 h following oral administration of the test formulation. The Tmax from formulation F10 was reached within a short period of time i.e. 0.48 ± 0.07 h after ingestion, comparable to Hifenac SR, which showed a Tmax of 0.56 ± 0.09 h. The Cmax shown by F10 was 6.86 ± 0.13, comparable to Hifenac SR, which showed a Cmax of 6.52 ± 0.15 h. Polyethylene oxide (PEO) has been widely used as a sustained release excipient in solid hydrophilic matrix preparations.6 Tablets made with PEO N60K (2 × 106) released the drug completely within 10 h because of the polymer’s property of concurrent swelling and erosion.